Features:
The HPA V281 was developped with the target to enable ultimate transmission quality for low- , medium- and high-impedance headphones.
Due to its specific, variable, low-noise and low-distortion circuit design especially optimised for dynamic headphones, the HPA V281 fulfils even most sophisticated demands.
HPA V281 is one of the few headphones amps made in Germany offering a balanced headphone output !!
Features:
• Balanced inputs with gold-plated Neutrik XLR connectors
• Unbalanced inputs with gold-plated RCA connectors
• Balanced line outputs with gold plated XLR connectors
• Unbalanced line outputs with gold plated RCA connectors
• Line outputs assignable to be with fixed or variable level
• 6 optional digital audio inputs 24 Bit / 96 or 192 kHz
• 3 switchable inputs with dedicated buttons on the front
• PRE-GAIN = switchable input gain in five steps
• Independent channel design
• ALPS RK27 High-Grade motorized volume control
• ALPS RK27 High Grade balance control
• High-Quality op-amps in the signal path
• High-quality MKP capacitors in the signal path
• 0.1 and 1% metal film resistors throughout the unit
• Discrete-design power amp with 32 transistors for audio purposes
• 4 amplifiers for true balanced headphone output
• 2 silver-plated Neutrik headphone outputs
• 1 gold plated Neutrik 4-pin XLR output
• Relay-based headphone output cut- off with delayed switch-on
• output management with dedicated buttons on the front:
• line outputs active, headphone outputs active, both active, both off (Mute)
• 2 x Large toroidal transformer (15 + 25 W)
• Large filtering capacitors in the power supply (36.000 uF)
• Switchable ground lift
• Rugged aluminium case with Nextel coating
• Solid, laser-engraved aluminium front panel
Technical Data: available at http://www.violectric.de/
This amp may be additionally equipped with one of optionaly available USB digital inputs either 24/96 kHz or 24/192 kHz