Features:
belt pack transmitter, dual AA battery, incl. pouch
superb, compandor-free audio quality
ultra-lightweight, corrosion resistant housing
water resistant seals for use in damp environments
programmable compatibility modes for use with a wide variety of different receivers
Frequency range: 256 frequencies in 100 kHz steps for one
25.5 MHz wide block
Channel Spacing: 100 kHz
Type of Modulation: FM
Frequency selection: Control panel mounted membrane switches
RF Power output: E01: 50 mW (nominal)
E02: 10 mW
Compatibility Modes: E01: Digital Hybrid Wireless® and IFB
E02: Digital Hybrid Wireless®, Mode 3, and IFB
Pilot tone: E01: 25 to 32 kHz; 3 kHz deviation in hybrid mode
E02: 1.9 kHz
Frequency stability: ± 0.002%
Deviation: ± 50 kHz max. in hybrid mode
Spurious radiation: Compliant ETSI EN 300 422-1
Equivalent input noise: –125 dBV, A-weighted
Input level:
If set for dynamic mic: 0.5 mV to 50 mV before limiting.
Greater than 1 V with limiting.
If set for electret lavaliere mic: 1.7 uA to 170 uA before limiting.
Greater than 5000 uA (5 mA) with limiting.
Line level input: 17 mV to 1.7 V before limiting.
Greater than 50 V with limiting.
Input impedance:
Dynamic mic: 300 Ohms
Electret lavaliere: Input is virtual ground with servo adjusted
constant current bias
Line level: 2.7 k Ohms
Input limiter: Soft limiter, 30 dB range
Bias voltages: Fixed 5 V at up to 5 mA
Selectable 2 V or 4 V servo bias for any
electret lavaliere.
Gain control range: 40 dB; panel mounted membrane switches
Modulation indicators: Dual bicolor LEDs indicate modulation of
-20, -10, 0, +10 dB referenced to
full modulation.
Controls: Control panel with LCD and four membrane
switches.
Low frequency roll-off: Adjustable from 35 to 150 Hz.