Features:
The new Klark Teknik DN100 V2 Direct Injection Box is the natural successor to the long-established LBB100.
A ground-up redesign provides an extended dynamic range, lower noise floor and all the world-class audio performance you’d expect from Klark Teknik. DN100 is also designed to handle the rigours of life on the road: a thick aluminium shell protects the electronics, and this in turn is protected by a tough silicone rubber casing, which is replaceable and available as a spare part.
Input
Type active electronic, balanced or unbalanced
Impedance 1M Ohm nominal, balanced or unbalanced (jack connectors) 20K Ohm (XLR input only)
Connectors 2 quarter inch jacks and 3-pin XLR linked in parallel
Maxmum level 30dBu
Attenuator 30dB switchable
Output
Type Transformer Isolated, balanced
Impedance 300 Ohm
Connector 3 pin XLR
Max. Level 10dBu with load >2k Ohm
Min. load 600 Ohm
Performance
Noise -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor
Frequency response +0.5/-1dB 20Hz to 20kHz
Distortion (THD+N) output <0.01% @ 1kHz, +4dBu
Power Requirement
Voltage +48V Phantom *
Current consumption <10mA