Производител
ADJ
AKG
BMS
CES
CME
D&R
DNH
DW
EMG
ESP
GHS
GLP
IFF
iSK
JBL
Jem
KEF
KRK
LP
MXR
NUX
QSC
RCF
TOA
UB+
UDG
VDB
Начало » DYNACORD » V600:2
DYNACORD V600:2
Описание:
2-Channel, 600 W Power Amplifier with Power Sharing for Commercial Installations


Perfect for small to mid-sized installation scenarios such as education, hospitality, retail, houses of worship and more. The four-channel power amplifier with a total power of 600 Watts is recommended as a go-to power amplifier for consultants, installers and specifiers who are looking for a sturdy, extremely versatile amplifier that is quick to install and runs trouble-free – even under demanding power conditions.

Features:

• powerTANK - Reservoir of available amplification power that is deployed flexibly across the 4 channels of the amplifier. There is no need to set up the powerTANK as it adapts to the requirements of each zone or output without extra manual configuration of each individual channel
• Variable Load Drive - Ensures that the powerTANK capacity is utilized efficiently, providing consistent power to any channel with any impedance. dualCOOL The dualCOOL thermal design means that the amplifier typically operates as a convection cooled amplifier, but in extreme thermal conditions the amplifier is also equipped with an intelligent multi?speed fan to ensure maximum performance and reliability in any application
• ecoRAIL - Power consumption is similar to a regular standby level, yet ecoRAIL still produces audio output suitable for background music levels, and the Auto Power Down (APD) mode can be engaged to further reduce power consumption to less than a watt when there is no signal present for extended periods
• PFC power supply - Equipped with a PFC power supply and protection features usually reserved for the professional power amplifiers, means that the amplifier resists complete shutdown situations and will always perform at its best under all conditions

Technical Specifications:

• Rated Output Power: 2 x 300 W
• Maximum Output Power per Channel (Power Sharing): 500 W / 600 W / 500 W / 600 W (4 ohm / 8 ohm / 70 V / 100 V)
• Total Rated Output Power: 600 W
• THD+N (1/8 Rated Output Power, 1 kHz): < 0.1 %
• Signal to Noise Ratio (A?Weighted, ref. to Rated Output Power, LEVEL 0 dB) @ 4 Ohms / 8 Ohms / 70 V / 100 V: > -100 dB / > 102 dB / > 101 dB / > 103 dB
• Output Stage Topology: Class D, Fixed Frequency
• Analog Audio Input: 2 x 6?Pin Euroblock, 3.81 mm, Male, Parallel 1x RJ45 AMP?LINK
• Loudspeaker Output: 2 x 4-Pin Euroblock, 5.08 mm, Female
• Control Port: 1 x 5?Pin Euroblock, 3.81 mm, Male
• Signal Processing: Input Routing, HPF 24 dB/ Oct., LPF 24 dB/Oct., Flat, Peak Limiter
• Power Requirements: 100 V to 240 V, 50 Hz to 60 Hz AC
• Idle Mode (ecoRAIL with no Input Signal): < 12 W
• Standby Mode (APD Active): < 1 W
• Power Supply Topology: Switching Power Supply with Power Factor Correction
• Protections: Audio Limiters, High Temperature, DC, HF, Short Circuit, Back?EMF, Peak Current Limiters, Inrush Current Limiters, Mains Over/Under Voltage Protection
• Front Status: LEDs Signal, Limit, Fault LEDs per Channel, Power LED
• Cooling Concept: Convection cooling in tabletop application and rack application with spacing between units. Forced cooling (side to rear) in rack application without spacing between units and in extreme thermal conditions.
• IEC Protection Class: Class I (Grounded)
• Dimensions (H x W x D) with 19" Mounting Brackets: 44.2 x 483 x 269.5 mm
• Weight: 3.6 kg
Цена
Купи
Наличност:
На склад

Гаранция: 12 месеца

бр.

Продуктът е наличен в
• София, Централен склад
бул. "Проф. Цветан Лазаров" 74А
Полезна информация:
Виж още:
DYNACORD
V600:4
2816.40 лв
В категории:
Multi-Channel Power Amps.
Installation Power Amplifiers