Описание:
IPX20:4 • DSP Power Amplifier • 4 x 5000 W @ 4 Ohms • OMNEO • 8 Dante / 4 Analog Inputs • Hi-Z Direct Drive • GPIOs • Euro-Block Connectors • 100 - 240V
Technical Specifications:
• Parallel, Bridged and Parallel-Bridged Drive Modes with 70/100V/140V/200V Direct Drive Modes and Low Impedance Low-Z Modes Operation
• Number of Amplifier Channels: 4
• Maximum Output Voltage, Normal Mode, per Channel: 210 Vpeak
• Maximum Output Current, Normal Mode, per Channel: 84 Apeak
• THD 3 dB Below max, AES17, 1 kHz: < 0.05 %
• DIM 100 3.15 kHz, 15 kHz: < 0.15 %
• IMD-SMPTE, 60 Hz, 7 kHz: < 0.05 %
• Crosstalk ref. 1 kHz, 12 dB Below max, 8 Ohms: < -80 dB
• Frequency Response, ref. 1 kHz, Analog into Speaker Out: 20 Hz to 20 kHz (±0.5 dB)
• Damping Factor, 20 Hz to 200 Hz, 8 ±: > 400
• Output Stage Topology: Class D
• SNR Amplifier A-Weighted, Analog / Digital Input: 115 dB / 118 dB
• Analog Audio Input/Thru Type: 2 x 6-Pin Euroblock, Male
• Speaker Output: 1 x 8-Pin Euroblock, 6mm, Female
• Rated Power Consumption: 2250 W
• 1/8 Maximum Output Power at 4 Ohms: 2850 W
• Sampling Rate: 48 kHz / 96 kHz, OMNEO/Dante Synchronized
• Signal Delay/Latency Analog into Speaker Out, 48 kHz/96 kHz: 0.70 ms / 0.53 ms
• Dante Network Latency: typ. 1.00 ms
• Signal Processing: User EQ, User Delay, Array EQ, Array Delay, Speaker EQ, Speaker X-Over, Speaker FIR, Speaker Limiters, Source Selection + Mix, Level, Mute, Polarity, Sine + Noise Generator, Pilot Tone Generator + Detection, Level Meters, Impedance Measurement + Load Monitoring
• DSP Presets: 1 Factory + 20 User
• Speaker-Pool Presets: 30 Speaker Settings
• Network Type: 2 x Neutrik EtherCON/RJ45, redundant PRIMARY/SECONDARY
• General: 1000base-T/100base-TX, Integrated Switch
• Network Audio Inputs: 8 Channels, 48/96 kHz, OMNEO/Dante Format
• Network Audio Outputs (Monitor): 2 Channels, 48/96 kHz, OMNEO/Dante Format
• GPIO Control Port Type: 1 x 8-Pin Euroblock, Male
• Ports + Operating Modes: 3 x GPIO, Switchable Analog In/Digital In/Digital Out